Manual of American Grape-Growing. U. P. Hedrick
is made by melting together one part of tallow, two parts of beeswax, and three parts of rosin."
Wire grafting.
"The merits claimed for this method are that it is more rapid, requires less skill, and does away with the troublesome tying and still more troublesome removal of the tying material. Practiced grafters can obtain as large a percentage of No. 1 unions by this method as by any other, and unpracticed grafters can do almost as well as practiced. Another advantage of the method is that the scions have less tendency to make roots than with the tongue graft.
"It consists essentially of the use of a short piece of galvanized iron wire inserted in the pith of stock and scion for the purpose of holding them together, thus replacing both tongues and raffia. It has been objected that the iron would have a deleterious effect on the tissues of the graft, corroding them, or causing them to decay. There seems, however, no reason to expect any such result, and vines grafted in this way have been bearing for years without showing any such effect.
"The preparation and grading of stocks and scions are exactly the same for this method as for the tongue graft.
"Stock and scion are cut at an angle of 45 degrees. A piece of galvanized iron wire two inches long is then pushed one inch into the firmest pith. This will usually be the pith of the stock, but it will depend on the varieties being grafted. The scion is then pushed on to the wire and pressed down until it is in contact with the stock. If the cuttings have large pith it is better to use two pieces of wire, one placed in the stock first and the other in the scion.
"The length of wire to use will vary with the size and firmness of the cuttings, but 2 inches will usually be found most satisfactory. Wire of No. 17 gauge is the most useful size."
Making bundles.
"If the grafts are to be planted out directly in the nursery, they may be simply laid in boxes or trays, covered with damp sacks, and carried out to be planted as soon as made. It is usually better, however, to place them for several weeks in a callusing bed before planting. In this case it is necessary for convenience of handling to tie them up into bundles. No more than twenty grafts should be placed in a bundle, and ten is better. If the bundles are too large there is danger of the grafts in the middle becoming moldy or dry.
"A stand is very convenient. It consists of a piece of board 12 inches, on one end of which is nailed a cleat 6 inches by 4 inches and under the other end a support of the same size. Two 4-inch wire nails are driven through the board from below, 4 inches apart and 5 inches from the cleat. Two other 4-inch nails are driven similarly at 11/2 inches from the other end. The grafts are laid on this stand with the scions resting against the cleat, and are then tied with the two pieces of bluestoned raffia that have previously been placed above each pair of nails. This arrangement insures all the scions, and therefore the unions, being at the same level, and puts both ties below the union where they will not strain the graft. The tying is more expeditious and less liable to disturb the unions than if the bundles are made without a guide.
"A skillful grafter will make about one hundred tongue grafts on cuttings per hour, or from sixty-five to seventy-five per hour if he does the tying as well. Wire grafts can be made at the rate of two hundred and fifty or more per hour, and by proper division of labor where several grafters are employed this number can be easily exceeded. These estimates do not include the preparation and grading of the cuttings."
Grafting rooted cuttings.
The cion may be grafted on a stock rooted in the nursery the previous season, much the same methods being used as with cuttings. This method is employed to utilize cuttings too small to graft, the added sizes attained in the nursery making them large enough, and in grafting on stocks which root with difficulty, thus saving the making of grafts which never grow. The stocks, in this method, are cut so that the cions may be inserted as the original cutting and not as the new growth. The roots, for convenience in handling, are cut back to an inch or thereabouts in length.
The callusing bed.
If bench grafts are planted at once in the nursery, most of them fail. They are, therefore, stratified in a callusing bed where moisture and temperature can be controlled. Bioletti describes a callusing bed and its use as follows:[6]
"This callusing bed is usually a pile of clean sand placed on the south side of a wall or building and surrounded by a board partition where there is no possibility of its becoming too wet by the flow of water from a higher level or from an overhanging roof. It should be protected, if necessary, by a surrounding ditch. It should be furnished with a removable cover of canvas or boards to protect it from rain and to enable the temperature to be controlled by the admission or exclusion of the sun's rays. A water-proof wagon-cover, black on one side and white on the other, is excellent for this purpose.
"The bottom of the callusing bed is first covered with 2 or 3 inches of sand. The bundles of grafts are then placed in a row along one end of the bed, and sand well filled in around them. The bundles should be placed in a slightly inclined position with the scions uppermost, and the sand should be dry enough so that it sifts in between the grafts in the bundle. The bundles of grafts are then covered up completely with sand, leaving it at least 2 inches deep above the top of the scion. Another row is then placed in the same manner until the bed is full. Finally a layer of 2 or 3 inches of moss or straw is placed over all.
"In the callusing bed we should endeavor to hasten and perfect the union of stock and scion as much as possible while delaying the starting of the buds and the emission of the roots. The latter processes require more moisture than the formation of healing tissue, therefore the sand should be kept comparatively dry. Between 5 and 10 per cent of water in the sand is sufficient. The purer the sand the less water is necessary. There should be a little more moisture present than in the sand used for keeping the cuttings over winter. Too much moisture will stimulate the emission of roots and starting of buds without aiding the callus formation.
"All the vital processes progress more rapidly when the cuttings are kept warm. To delay them, therefore, we keep the sand cool, and to hasten them we make it warm. In the beginning of the season and up to the middle of March we keep the sand cool. This is done by keeping the bed covered during the day when the sun is shining, and uncovering occasionally at night when there is no fear of rain. If the black-and-white wagon-cover is used, the white side should be placed outward to reflect the heat. The temperature should be kept about 60° F. or lower.
"About the middle of March the temperature of the bed should be raised. This is done by removing the cover during warm days and carefully covering at night. If necessary the layer of moss or straw should be removed on sunny days and then replaced. The temperature of the sand at the level of the unions should be about 75° F. during this period. If the temperature rises higher than this, there will be a more abundant production of callus, but it will be soft, easily injured, and liable to decay.
"At the end of four weeks after warming the bed, the union should be well cemented. The callus should not only have formed copiously around the whole circumference of the wound, but it should have acquired a certain amount of toughness due to the formation of fibrous tissue. It should require a pull of several pounds to break the callus and separate stock and scion. When the callus has acquired this quality the grafts are in condition to be planted in the nursery, and may be handled without danger. If taken from the bed while the callus is still soft, many unions will be injured and the grafts will fail, or unite only on one side.
"If left as long as this in the callusing bed most of the scion buds will have started and formed white shoots. These shoots, however, should not be more than 1/2 to 1 inch long. If they are longer the bed has been kept too wet or too warm. Roots will also have started from the stock, but these also should not be over 1/2 inch long. The grafts should be handled as carefully as is practicable, but there is no objection to breaking off any scion shoots or stock roots which have grown too long. It is almost impossible to save them, and new ones will start after the grafts are planted, and