A System of Instruction in the Practical Use of the Blowpipe. Unknown
Nitrate of Cobalt.—(CoO, NO5).—This salt can be prepared by dissolving pure oxide of cobalt in diluted nitric acid, and evaporating to dryness with a low heat. The dry residue should be dissolved in ten parts of water, and filtered. The filtrate is now ready for use, and should be kept in a bottle with a glass stopper. If the pure oxide of cobalt cannot be procured, then it may be prepared by mixing two parts of finely powdered glance of cobalt with four parts of saltpetre, and one part of dry carbonate of potassa with one part of water free from carbonate of soda. This mixture should be added in successive portions into a red-hot Hessian crucible, and the heat continued until the mass is fused, or at least greatly diminished in volume. The cooled mass must be triturated with hot water, and then heated with hydrochloric acid until it is dissolved and forms a dark green solution, which generally presents a gelatinous appearance, occasioned by separated silica. The solution is to be evaporated to dryness, the dry residue moistened with hydrochloric acid, boiled with water, filtered and neutralized while hot with carbonate of ammonia, until it ceases to give an acid reaction with test-paper. This must now be filtered again, and carbonate of potassa added to the filtrate as long as a precipitate is produced. This precipitate is brought upon a filter and washed thoroughly, and then dissolved in diluted nitric acid. This is evaporated to dryness, and one part of it is dissolved in ten parts of water for use.
The oxide of cobalt combines, with strong heat in the oxidation flame, with various earths and infusible metallic oxides, and thus produces peculiarly colored compounds, and is therefore used for their detection; (alumina, magnesia, oxide of zinc, oxide of tin, etc.) Some of the powdered substance is heated upon charcoal in the flame of oxidation, and moistened with a drop of the solution of the nitrate of cobalt, when the oxidation flame is thrown upon it. Alumina gives a pure blue color, the oxide of zinc a bright green, magnesia a light red, and the oxide of tin a bluish-green color; but the latter is only distinctly visible after cooling.
The dropping bottle, is the most useful apparatus for the purpose of getting small quantities of fluid. It is composed of a glass tube, drawn out to a point, with a small orifice. This tube passes through the cork of the bottle. By pressing in the cork into the neck of the bottle, the air within will be compressed, and the liquid will rise in the tube. If now we draw the cork out, with the tube filled with the fluid, and pressing the finger upon the upper orifice, the fluid can be forced out in the smallest quantity, even to a fraction of a drop.
10. Tin.—This metal is used in the form of foil, cut into strips about half an inch wide. Tin is very susceptible of oxidation, and therefore deprives oxidized substances of their oxygen very quickly, when heated in contact with them. It is employed in blowpipe analysis, for the purpose of producing in glass beads a lower degree of oxidation, particularly if the substance under examination contains only a small portion of such oxide. These oxides give a characteristic color to the bead, and thus are detected. The bead is heated upon charcoal in the reduction flame, with a small portion of the tin, whereby some of the tin is melted and mixes with the bead. The bead should be reduced quickly in the reduction flame, for by continuing the blast too great a while, the oxide of tin separates the other oxides in the reduced or metallic state, while we only require that they shall only be converted into a sub-oxide, in order that its peculiar color may be recognized in the bead. The addition of too much tin causes the bead to present an unclean appearance, and prevents the required reaction.
11. Silica (SiO3).—This acid does not even expel carbonic acid in the wet way, but in a glowing heat it expels the strongest volatile acids. In blowpipe analysis, we use it fused with carbonate of soda to a bead, as a test for sulphuric acid, and in some cases for phosphoric acid. Also with carbonate of soda and borax, for the purpose of separating tin from copper.
Finely powdered quartz will answer these purposes. If it cannot be procured, take well washed white sand and mix it with two parts of carbonate of soda and two parts of carbonate of potassa. Melt the materials together, pound up the cooled mass, dissolve in hot water, filter, add to the filtrate hydrochloric acid, and evaporate to dryness. Moisten the dry residue with hydrochloric acid, and boil in water. The silica remains insoluble. It should be washed well, dried, and heated, and then reduced to powder.
12. TEST-PAPERS.—(a.) Blue, Litmus Paper.—Dissolve one part of litmus in six or eight parts of water, and filter. Divide the filtrate into two parts. In one of the parts neutralize the free alkali by stirring it with a glass rod dipped in diluted sulphuric acid, until the fluid appears slightly red. Then mix the two parts together, and draw slips of unsized paper, free from alkali, such as fine filtering paper. Hang these strips on a line to dry, in the shade and free from floating dust. If the litmus solution is too light, it will not give sufficient characteristic indications, and if too dark it is not sensitive enough. The blue color of the paper should be changed to red, when brought in contact with a solution containing the minutest trace of free acid; but it should be recollected that the neutral salts of the heavy metals produce the same change.
(b.) Red Litmus Paper.—The preparation of the red litmus paper is similar to the above, the acid being added until a red color is obtained. Reddened litmus paper is a very sensitive reagent for free alkalies, the carbonates of the alkalies, alkaline earths, sulphides of the alkalies and of the alkaline earths, and alkaline salts with weak acids, such as boracic acid. These substances restore the original blue color of the litmus.
(c.) Logwood Paper.—Take bruised logwood, boil it in water, filter, and proceed as above. Logwood paper is a very delicate test for free alkalies, which impart a violet tint to it. It is sometimes used to detect hydrofluoric acid, which changes its color to yellow.
All the test-papers are to be cut into narrow strips, and preserved in closely stopped vials. The especial employment of the test-papers we shall allude to in another place.
B. ESPECIAL REAGENTS
13. Fused Boracic Acid (BO3).—The commercial article is sufficiently pure for blowpipe analysis. It is employed in some cases to detect phosphoric acid, and also minute traces of copper in lead compounds.
14. Fluorspar (CaFl2).—This substance should be pounded fine and strongly heated. Fluorspar is often mixed with boracic acid, which renders it unfit for analytical purposes. Such an admixture can be detected if it be mixed with bisulphate of potassa, and exposed upon platinum wire to the interior or blue flame. It is soon fused, the boracic acid is reduced and evaporated, and by passing through the external flame it is reoxidized, and colors the flame green. We use fluorspar mixed with bisulphate of potassa as a test for lithia and boracic acid in complicated compounds.
15. Oxalate of Nickel (NiO, O).—It is prepared by dissolving the pure oxide of nickel in diluted hydrochloric acid. Evaporate to dryness, dissolve in water, and precipitate with oxalate of ammonia. The precipitate must be washed with caution upon a filter, and then dried. It is employed in blowpipe analysis to detect salts of potassa in the presence of sodium and lithium.
16. Oxide of Copper (CuO).—Pure metallic copper is dissolved in nitric acid. The solution is evaporated in a porcelain dish to dryness, and gradually heated over a spirit-lamp, until the blue color of the salt has disappeared and the mass presents a uniform black color. The oxide of copper so prepared must be powdered, and preserved in a vial. It serves to detect, in complicated compounds, minute traces of chlorine.
17. Antimoniate of Potassa (KO, SbO6).—Mix four parts of the bruised metal of antimony, with nine parts of saltpetre. Throw this mixture, in small portions, into a red-hot Hessian crucible, and keep it at a glowing heat for awhile after all the mixture is added. Boil the cooled mass with water, and dry the residue. Take two parts of this, and mix it with one part of dry carbonate of potassa, and expose this to a red heat for about half an hour. Then wash the mass in cold water, and boil the residue in water; filter, evaporate the filtrate to dryness, and then, with a strong heat, render it free of water. Powder it while it is warm, and preserve it in closed vials. It is used for the detection of small quantities of charcoal in compound substances, as it shares its oxygen with the carbonaceous matter, the antimony becomes separated, and carbonate of potassa is produced, which restores red litmus paper to blue, and effervesces with acids.
18. Silver Foil.—A small piece of silver foil is used for the purpose