Space Physics and Aeronomy, Ionosphere Dynamics and Applications. Группа авторов
form of energy input, far exceeding the energy attributed to auroral particle precipitation. The ration of Joule heat to auroral precipitation power ranges from a factor of 2 on average, to greater than an order of magnitude during large magnetic storms.
Figure 1.1 Solar power, particle power, and Joule power from 1975–2003
(reproduced from Fig. 4, Knipp et al., 2004. Reproduced with permission of Springer Nature).
From equation (1.2), Joule heat due to dissipation of electromagnetic energy is
(1.4)
This is equivalent to
where σ is the conductivity (Banks et al., 1981). Radar measurements of the ion convection determine E. Combining E with models of the conductivity, Q, can be calculated. A comparison of the electromagnetic to particle power shows a ratio ranging from 1 (Brekke, 1976; Banks, 1977) to 4 (Ahn et al., 1983b). In these studies, there is a focus on the auroral zone due to the location of radar observatories, which determine not only E but, to a large extent, σ as well (Ahn et al., 1983a).
A more direct measure of incoming EM power is to calculate the Poynting flux entering the ionosphere, which obviates the need to use a model for conductivity. This was done by Huang and Burke (2004) for a superstorm during which four DMSP spacecraft measured large FACs simultaneous with intense electric fields. It should be noted that the calculation of Poynting flux from DMSP usually uses only the two components of horizontal velocity perpendicular to the ram direction. There is uncertainty in the measured ram velocity and this component is omitted. The estimated EM power over a 20‐minute interval measured by DMSP was approximately 500 GW, comparable with the solar power over the dayside hemisphere shown in Figure 1.1. A second point in our discussion is that while all four DMSP spacecraft crossing the current sheet measured magnetometer deflections of greater than 1,200 nT magnetometers, at conjugate locations on the ground magnetometers measured deflections of the order of a few tens of nT. This point will be discussed in more detail below. It is widely accepted that Poynting flux dominates the total energy input in the IT system during periods of magnetic activity. This was confirmed in a detailed study of the energy budget for a magnetic storm on 5–6 August 2011 (Huang et al., 2014). While particle energy may not be dominant in considerations of total energy deposition, it plays a leading role in energy dissipation via conductivity as shown in equation (1.5).
Ionospheric conductivites are described by Maeda (1977) and in the World Data Center A (Kyoto) website (http://wdc.kugi.kyoto‐u.ac.jp/ionocond/exp/icexp.html). A number of models of conductivity and conductance have been derived based on particle precipitation (Fuller‐Rowell & Evans, 1987; Wallis & Budzinski, 1981; Spiro et al., 1982; Roble & Ridley, 1987; Hardy et al., 1987; Robinson et al., 1987; Gjerloev & Hoffman, 2000; McGranaghan et al., 2016, & others). Models have also been developed, which are based on UV observations (e.g., Lummerzheim et al.,1991; Coumans et al., 2004), and which account for proton precipitation (Galand & Richmond, 2001; Coumans et al., 2004). The complexity of the conductivity resulting from particle precipitation has been emphasized by McGranaghan et al. (2016), who point out that three‐dimensional spatial variations in even the average precipitation patterns are normal. When temporal variability is added, the task of capturing conductivity accurately becomes even more challenging.
1.2.2 The Weimer Model
A series of papers by Weimer (1995; 2005) provided an empirical model of EM energy input to the IT system, based on observations of electric and magnetic fields by Dynamics Explorer 2 (DE2). The model represents the high‐latitude (|λ|> 45° MLat) electric potentials as spherical harmonics, which were correlated with measured interplanetary magnetic field (IMF) (Weimer 1995). Examples of the electric potentials in the Northern Hemisphere, shown in Figure 1.2, are generated for solar wind and IMF input by the Weimer (2005) model, hereafter abbreviated as W05. Empirical maps of the FACs were also developed, using scalar magnetic Euler potentials (Weimer, 2001). Figure 1.3 illustrates the magnetic Euler potentials for the same solar wind and IMF as in Figure 1.2. A combination of the electric potentials with the FACs from the Euler potentials yields Poynting flux. In steady state, the Poynting flux into the ionosphere is approximately equal to the energy dissipated by Joule heating. This assumes that energy, which is used to generate neutral winds, is negligible, an assumption which may not always be true (Thayer & Semeter, 2004). One of the advantages of this model is that Joule heat can be estimated directly without the need for an estimate of conductivity.
Figure 1.2 (a)–(i) Polar cap electric potentials in the Northern Hemisphere, mapped as a function of AACGM latitude and MLT. Figures (a)–(d) and (f)–(i) show the patterns for eight different clock angle orientations of the IMF vector in the GSM Y‐Z plane; the angle in degrees is indicated in the top left corner of each map. The IMF has a fixed magnitude of 5 nT, the solar wind velocity is 450 km s‐1, the solar wind number density is 4 cm‐3, and the dipole tilt angle is 0°. Figure (e) shows the potential for zero IMF, with the same solar wind conditions. Minimum and maximum potential values are printed in the bottom left and right corners of each map, with locations indicated by the diamonds and pluses.
(reproduced from Fig. 2, Weimer et al., 2005. Reproduced with permission of John Wiley & Sons).
Figure 1.3 (a)–(i) Magnetic Euler potentials in the Northern Hemisphere, mapped as a function of AACGM latitude and MLT. The format and the IMF/solar wind parameters are the same as in Figure 1.2.
(reproduced from Fig. 3, Weimer et al., 2005. Reproduced with permission of John Wiley & Sons).
As in any empirical model, the results are obtained by averaging over observations. In the case of the Weimer model, the observations are obtained from the approximately 18‐month lifetime of the DE2 mission. Despite the