Handbook of Enology, Volume 2. Pascal Ribéreau-Gayon
al., 1982).
1.4 The Concept of pH and Its Applications
1.4.1 Definition
The concept of pH often appears to be an abstract, theoretical one, defined mathematically as the base ten logarithm of the concentration of hydronium ions in an electrically conductive solution, such as must or wine:
Furthermore, the expression of pH shows that it is an abstract measure with no units, i.e. with no apparent concrete physical significance.
The concepts of total or volatile acidity seem to be easier to understand as they are measured in milliliters of sodium hydroxide and expressed in grams of sulfuric or tartaric acid per liter. This is rather paradoxical as the total acidity in a wine is, in fact, a complex function with several variables, unlike pH, which refers to only one variable, the true concentration of hydronium ions in must and wine.
The idea that pH is an abstract concept is even less justified since this physicochemical parameter is based on the dissociation equilibrium of the various acids, HA, in wine, at fixed temperature and pressure, as shown below:
The emission of H3O+ ions defines the acidity of the HA molecule. Dissociation depends on the value of the equilibrium constant, Ka, of the acid:
(1.1)
The usefulness of pH, also known as true acidity, is supported by the fact that its value rather accurately matches the impressions of acidity frequently described as “freshness” or even “greenness” and “thinness,” especially in white wines.
A wine's pH is measured using a pH meter equipped with a glass electrode after calibration with two buffer solutions. It is vital to check the temperature.
Owing to the presence of tartaric acid (a strong acid), the pH values of wines range from 2.8 to 4.0. It is surprising to find such low nonphysiological values in a biological fermentation medium such as wine. Indeed, life is only possible thanks to enzymes in living cells, and the optimum activity of the vast majority of enzymes occurs at much higher intracellular pH values, close to neutral, rather than those prevailing in extracellular media, i.e. must and wine. This provides some insight into the role of cell membranes and their ATPases in regulating proton input and output.
On the other hand, it is a good thing that wines have such low pH values, as this enhances their microbiological and physicochemical stability. Low pH hinders the development of microorganisms while increasing the antiseptic fraction of sulfur dioxide. The influence of pH on physicochemical stability is due to its effect on the solubility of tartrates, in particular potassium bitartrate but, above all, calcium tartrate and the double salt calcium tartromalate.
Iron casse, or iron haze, is also affected by pH. Indeed, iron (III), or ferric iron, establishes soluble complexes with molecules such as citric acid. These complexes are destabilized by increasing pH to produce insoluble salts, such as ferric phosphates (see “white casse”) or even ferric hydroxide, Fe(OH)3.
1.4.2 Expression of pH in Wine
Wines are mixtures of weak acids, combined to form salts to a greater or lesser extent according to their pKa (Table 1.3). The proportion of salts also depends on geographical origin, grape variety, the way the vines are trained, and the pressing and winemaking methods used.
Due to their composition, musts and wines are acid–base “buffer” solutions, i.e. a modification in their chemical composition produces only a limited variation in pH. This explains the relatively small variations in the pH of must during alcoholic and malolactic fermentations.
The pH of a solution containing a weak monoprotic acid and its strong basic salt proves the Henderson–Hasselbalch equation:
This equation is applicable to must and wine, where the most important acids are diacids. It is an approximation, assuming the additivity of the acidity contributed by each acid to the total. The application of Equation (1.2) also makes the simplifying assumption that the degree to which the acids are combined in salts is independent of each other. These assumptions are currently being challenged. Indeed, recent research has shown that organic acids react among themselves, as well as with amino acids (Dartiguenave et al., 2000a).
FIGURE 1.3 Comparison of the titration curves of a must and the corresponding wine.
Comparison (Table 1.3) of the pKa values of tartaric (3.01), malic (3.46), lactic (3.81), and succinic (4.18) acids leads to the conclusion that tartaric acid is the “strongest,” so it will take priority in forming salts, displacing, at least partially, the weaker acids. In reality, all of the acids interact. Experimental proof of this is given by the neutralization curve of a must, or the corresponding wine, obtained using sodium or potassium hydroxide (Figure 1.3). These curves have no inflection points at pH corresponding to the pKa values of the various acids, as there is at least partial overlapping of the maximum “buffer” zones (pKa ± 1). Thus, the neutralization curves are quasi‐linear for pH values ranging from 10 to 90% neutralized acidity. They therefore indicate a constant buffer capacity in this zone. From a more quantitative standpoint, a comparison of the neutralization curves of must and the corresponding wine shows that the total acidity values, assessed by the volume of sodium hydroxide added to obtain pH 7, differ by 0.55 mEq. In the example described above, both must and wine samples were 50 ml, and the total acidity of the wine was 11 mEq/l (0.54 g/l as H2SO4) lower than that of the must. This drop in total acidity in wine may be attributed to a slight consumption of malic acid by the yeast during alcoholic fermentation, as well as a partial precipitation of potassium bitartrate (insoluble in alcohol).
The slope of the linear segment of the two neutralization curves differs noticeably. The curve corresponding to the must has a gentler slope, showing that it has a greater buffer capacity than the wine.
The next paragraph gives an in‐depth description of this important physicochemical parameter of wine.
1.4.3 The “Buffer” Capacity of Musts and Wines
The acid–base buffer capacity of wines is largely responsible for their physicochemical and microbiological stability, as well as their flavor balance. For example, the length of time a wine leaves a fresh impression on the palate is directly related to the formation of acid salts by basic proteins in saliva, i.e. the expression of the buffer phenomenon and its capacity. In contrast a wine that tastes “flat” has a low buffer capacity, but this does not necessarily mean that it has a low acidity level. At a given total acidity level, buffer capacity varies according to the composition and type of acids present. This point will be developed later in this chapter.
In